yet it still tried to test past the 64GB mark. If my bios or especially memtest had mis-identified my amount of RAM as 128GB then I wouldn't be worried, but every screen in my BIOS and even memtest itself saw that I had 64GB. I really hope that was it, though the errors in memtest concern me. Just to make sure I tried disabling XMP and they went down to 2666, re-enabled it and it right back to 3600 with no complaints. which considering that I only have 64GB of RAM installed in that thing.Īnyway, after I plugged them into A2 and B2 it immediately came up as 3600. I checked the manual, and when you have two sticks it recommends installing them in slots A2 and B2, I had them installed in A1 and B1.Īnd when I went back to correct this, I noticed that memtest86+ had tossed out hundreds of errors. This looks like it might have been the problem. but that was from Micro Center, which I was told I generally could trust open box items from. I did get both the RAM and the CPU as open box. Should I be worried? Or is this normal behavior for the BIOS? I haven't installed an OS yet to check there as I want to let Memtest86+ run for a while first. I did notice that sometimes, like my CPU speed, it could fluctuate in the BIOS, but never go above 3200. I noticed that it said my RAM speed was 3200Mhz, when it's supposed to be 3600 and the XMP profile is identifying it as 3600 in the BIOS. I tried rebooting with XMP turned on and OFF and it seemed to have no trouble posting. However, after that, it seems to POST with XMP enabled just fine. The first time I attempted that, it did not reboot, then claimed it had detected a boot error. Then the second thing I did was enable XMP. Don't even have any additional fans or drives in the case yet.Īnyway, first thing I did after it posted was update my motherboard's BIOS to the latest version. I just setup the bare minimum needed for a system to POST.Ī z490 motherboard, a 10700k cpu, a cooler, 3600mhz RAM, and a psu.
0 Comments
Leave a Reply. |